Daikin E8 error code

What it means

E8 means the outdoor unit detected AC input current outside the allowed range. This is an electrical/protection code, not a homeowner repair.

Urgency

Likely causes

1. Brief power event, brownout, or unstable supply voltage
2. Loose power connection, reactor, or outdoor electrical component problem
3. Inverter/IPM protection or current-detection fault
4. Compressor winding, drive, or outdoor board fault after power checks pass

Homeowner fix

Turn the system off and note whether lights dimmed, storms occurred, generator power was used, or other circuits had trouble. Reset once only after power is stable. If the code returns or a breaker trips, leave the system off.

When to call a pro

Call a licensed HVAC technician or electrician if E8 returns or any breaker trips. Tell them the code is input overcurrent detection.

Repair vs replace

This is normally repairable, but it is not a homeowner repair. If the unit is older, out of warranty, or a technician quotes a major compressor, inverter, board, or sealed-system repair, compare the quote with replacement.

• Daikin AURORA 9,000 BTU R-32 208/230V (FTXV09AVJU9 / RXT09AVJU9)

  AURORA R-32

• Daikin AURORA 12,000 BTU R-32 208/230V (FTXV12AVJU9 / RXT12AVJU9)

  AURORA R-32

• Daikin AURORA 15,000 BTU R-32 208/230V (FTXV15AVJU9 / RXT15AVJU9)

  AURORA R-32

• Daikin AURORA 18,000 BTU R-32 208/230V (FTXV18AVJU9 / RXT18AVJU9)

  AURORA R-32

Parts for this line

The parts catalog for Daikin AURORA R-32 lists 7 sourced replacement parts for this product line.

For your technician

Technician note: verify supply voltage/current under load, wiring, compressor current, inverter/IPM condition, and current-detection circuit. Page context: Daikin maps this display to the AURORA R-32 line; source: Daikin Nineteen, ATMOSPHERA, Entra, and MXM/MXT/MXTH local service manuals; display convention: match the letter E and eight marker exactly before comparing neighboring codes.

Which systems show it

• Daikin current US residential R-32 ductless single-zone systems, including AURORA R-32, ATMOSPHERA R-32, Entra R32, OTERRA R-32, and Nineteen-series style high-wall diagnostics where the same Daikin A/C/E/F/H/J/L/P/U code family is used.
• Daikin concealed-duct/FDMQ indoor units where the Nineteen service manual explicitly lists the same indoor drain, fan PCB, remote-controller, and FDMQ-only C/U codes.
• Daikin AURORA Multi R-32 and Standard Multi R-32 MXT/MXTH/MXM systems where the MXM engineering manual lists the same homeowner code table.
• MXM/MXT/MXTH multi-zone systems for the additional multi-zone U-series and inverter/control codes specifically called out from the MXM manual.

Related troubleshooting

Use the symptom guide alongside the exact display code if the unit is flashing, cycling, or showing comfort symptoms.

Reset note

Turn the system off and note whether lights dimmed, storms occurred, generator power was used, or other circuits had trouble. Reset once only after power is stable. If the code returns or a breaker trips, leave the system off.

Manual trigger

E8 means the outdoor unit detected AC input current outside the allowed range. This is an electrical/protection code, not a homeowner repair.

Related codes

Source

Next step