Daikin U4 error code

What it means

U4 means the indoor and outdoor units are not communicating reliably. The system may stop because the two halves of the heat pump cannot coordinate safely.

Urgency

Likely causes

1. Brief power event, brownout, or unstable supply voltage
2. Loose power connection, reactor, or outdoor electrical component problem
3. Inverter/IPM protection or current-detection fault
4. Compressor winding, drive, or outdoor board fault after power checks pass

Homeowner fix

Turn the system off with the remote, then power cycle once at the breaker or disconnect if you can do that safely. Expected result: a temporary control fault clears; if the code returns, stop resetting and schedule service.

When to call a pro

Call a licensed HVAC technician if U4 returns after one reset, appears on a new install, or more than one indoor head is affected. Tell them it is indoor/outdoor transmission.

Repair vs replace

Sensor and communication faults are usually repairable. Compare repair with replacement only if the system is older, out of warranty, or multiple boards or sensors are being quoted together.

• Daikin AURORA 9,000 BTU R-32 208/230V (FTXV09AVJU9 / RXT09AVJU9)

  AURORA R-32

• Daikin AURORA 12,000 BTU R-32 208/230V (FTXV12AVJU9 / RXT12AVJU9)

  AURORA R-32

• Daikin AURORA 15,000 BTU R-32 208/230V (FTXV15AVJU9 / RXT15AVJU9)

  AURORA R-32

• Daikin AURORA 18,000 BTU R-32 208/230V (FTXV18AVJU9 / RXT18AVJU9)

  AURORA R-32

Parts for this line

The parts catalog for Daikin AURORA R-32 lists 7 sourced replacement parts for this product line.

For your technician

Technician note: check terminal order, communication voltage, wiring continuity, grounding/noise, and indoor/outdoor board communication diagnosis. Page context: Daikin maps this display to the AURORA R-32 line; source: Daikin Nineteen, ATMOSPHERA, Entra, and MXM/MXT/MXTH local service manuals; display convention: match the letter U and four marker exactly before comparing neighboring codes.

Which systems show it

• Daikin current US residential R-32 ductless single-zone systems, including AURORA R-32, ATMOSPHERA R-32, Entra R32, OTERRA R-32, and Nineteen-series style high-wall diagnostics where the same Daikin A/C/E/F/H/J/L/P/U code family is used.
• Daikin concealed-duct/FDMQ indoor units where the Nineteen service manual explicitly lists the same indoor drain, fan PCB, remote-controller, and FDMQ-only C/U codes.
• Daikin AURORA Multi R-32 and Standard Multi R-32 MXT/MXTH/MXM systems where the MXM engineering manual lists the same homeowner code table.
• MXM/MXT/MXTH multi-zone systems for the additional multi-zone U-series and inverter/control codes specifically called out from the MXM manual.

Related troubleshooting

Use the symptom guide alongside the exact display code if the unit is flashing, cycling, or showing comfort symptoms.

Reset note

Turn the system off with the remote, then power cycle once at the breaker or disconnect if you can do that safely. Expected result: a temporary control fault clears; if the code returns, stop resetting and schedule service.

Manual trigger

U4 means the indoor and outdoor units are not communicating reliably. The system may stop because the two halves of the heat pump cannot coordinate safely.

Related codes

Source

Next step