Midea PC00 error code

What it means

PC00 means the outdoor inverter power module reported an abnormal compressor-drive condition. It can shut the system down to protect expensive electronics and the compressor.

Urgency

Likely causes

1. Brief power event, brownout, or unstable supply voltage
2. Loose power connection, reactor, or outdoor electrical component problem
3. Inverter/IPM protection or current-detection fault
4. Compressor winding, drive, or outdoor board fault after power checks pass

Homeowner fix

Turn the system off with the remote, then power cycle once at the breaker or disconnect if you can do that safely. Expected result: a temporary control fault clears; if the code returns, stop resetting and schedule service.

When to call a pro

Call a licensed HVAC technician if PC00 returns after one reset. Tell them the code is outdoor IPM module protection.

Repair vs replace

This is normally a repair diagnosis, not an automatic replacement signal. If a technician confirms a major board, compressor, fan motor, or refrigerant-circuit repair on older out-of-warranty equipment, compare the quote with replacement.

• Midea Advantage Series Multi-Zone 3-Zone 18,000 BTU R-454B 208/230V (D5CMRAH18CAK)

  Advantage Series Multi-Zone

• Midea Advantage Series Multi-Zone 4-Zone 24,000 BTU R-454B 208/230V (D5CMRAH24DAK)

  Advantage Series Multi-Zone

• Midea Advantage Series Multi-Zone 5-Zone 30,000 BTU R-454B 208/230V (D5CMRAH30EAK)

  Advantage Series Multi-Zone

• Midea Advantage Series Multi-Zone 5-Zone 36,000 BTU R-454B 208/230V (D5CMRAH36EAK)

  Advantage Series Multi-Zone

For your technician

Technician note: section 7.4.2.13 lists wiring mistake, IPM, outdoor fan assembly, compressor, and outdoor PCB for P6/PC00. Page context: Midea maps this display to the Advantage Series Multi-Zone line; source: Midea D5CMRA Installation Instructions Table 20 and shared ACiQ/Midea Multi-Zone Service Manual; display convention: match the letter P, letter C, and zero marker exactly before comparing neighboring codes.

Which systems show it

• Midea Advantage Series Multi-Zone D5CMRA R-454B outdoor condensers and matched indoor units covered by Table 20.
• Midea Advantage Series Multi-Zone High-Heat D5CMHA systems where the D5C installation/error-code convention is shared.
• Midea current R-454B single-zone high-wall families when the indoor display uses the same EC/EH/EL/PC homeowner code convention.

Sold under more than one brand

Also sold as ACiQ. Midea and ACiQ document this code from the same manufacturer source, so PC00 means the same thing on either badge and the steps above apply.

Related troubleshooting

Use the symptom guide alongside the exact display code if the unit is flashing, cycling, or showing comfort symptoms.

Reset note

Turn the system off with the remote, then power cycle once at the breaker or disconnect if you can do that safely. Expected result: a temporary control fault clears; if the code returns, stop resetting and schedule service.

Manual trigger

PC00 means the outdoor inverter power module reported an abnormal compressor-drive condition. It can shut the system down to protect expensive electronics and the compressor.

Related codes

Source

Next step