MRCOOL FH CC error code

What it means

FH CC means the indoor unit reports a refrigerant sensor error after receiving a fault signal or losing sensor feedback. The manual trigger fits the sensor, detector, or thermistor circuit category.

Urgency

Likely causes

1. Sensor, detector, or thermistor reading outside its documented range
2. Loose connector or damaged sensor lead
3. Moisture, corrosion, or vibration affecting the sensing circuit
4. Control board input fault after the sensor or detector checks out

Homeowner fix

Power cycle once only when the page includes a reset procedure, and make sure accessible air paths are not blocked. Do not open cabinets to test sensors or detectors. If the code returns, write down the exact display and stop there.

When to call a pro

Call a licensed HVAC technician if FH CC remains or returns. Tell them the manual trigger is "The indoor unit reports a refrigerant sensor error after receiving a fault signal or losing sensor feedback" and point them to 4.7 TS05-N10: Refrigerant sensor error diagnosis and solution.

Repair vs replace

Sensor, detector, and thermistor repairs are usually smaller than system replacement. Replacement becomes a comparison only if diagnosis leads to a major board or refrigerant-circuit repair on an older system.

• MRCOOL DIY 5th Gen 9,000 BTU (115V)

  DIY 5th Generation

• MRCOOL DIY 5th Gen 12,000 BTU (115V)

  DIY 5th Generation

• MRCOOL DIY 5th Gen 18,000 BTU (230V)

  DIY 5th Generation

• MRCOOL DIY 5th Gen 24k marketed / 23,000 BTU rated (230V)

  DIY 5th Generation

Parts for this line

The parts catalog for MRCOOL DIY 5th Generation lists 10 sourced replacement parts for this product line.

For your technician

Technician note: follow 4.7 TS05-N10: Refrigerant sensor error diagnosis and solution. The sourced steps start with licensed refrigerant-circuit checks for leakage, charge, restriction, and safe repair before parts are replaced. Page context: MRCOOL maps this display to the DIY 5th Generation line; source: MRCOOL R454B DIY-5 service manual.

Which systems show it

• MRCOOL DIY 5th Generation single-zone 9k, 12k, 18k, 24k, and 36k D25 indoor/outdoor models listed in manual section 1.1.

Related troubleshooting

Use the symptom guide alongside the exact display code if the unit is flashing, cycling, or showing comfort symptoms.

Manual trigger

The indoor unit reports a refrigerant sensor error after receiving a fault signal or losing sensor feedback.

Related codes

Source

Next step