MRCOOL PH 90 error code

What it means

PH 90 means high temperature protection of the evaporator. The manual identifies the condition but does not tie it to a broader cause family.

Urgency

Likely causes

1. Temporary protection condition
2. Sensor or control fault
3. Refrigerant or airflow issue a technician must confirm

Homeowner fix

Use only the homeowner steps documented on this page. Do not infer a reset or open the equipment when the manual does not provide one. If the code returns, write down the exact display and stop there.

When to call a pro

Call a licensed HVAC technician if PH 90 remains or returns. Tell them the manual trigger is "High temperature protection of the evaporator" and point them to 4.3 Error Display (Outdoor Unit with Auxiliary Board).

Repair vs replace

The code alone does not establish whether repair or replacement makes sense. Base that decision on the model-specific diagnosis and repair quote.

• MRCOOL DIY 5th Gen 9,000 BTU (115V)

  DIY 5th Generation

• MRCOOL DIY 5th Gen 12,000 BTU (115V)

  DIY 5th Generation

• MRCOOL DIY 5th Gen 18,000 BTU (230V)

  DIY 5th Generation

• MRCOOL DIY 5th Gen 24k marketed / 23,000 BTU rated (230V)

  DIY 5th Generation

Parts for this line

The parts catalog for MRCOOL DIY 5th Generation lists 10 sourced replacement parts for this product line.

For your technician

Technician note: follow 4.3 Error Display (Outdoor Unit with Auxiliary Board) for the trigger "High temperature protection of the evaporator". Page context: MRCOOL maps this display to the DIY 5th Generation line; source: MRCOOL R454B DIY-5 service manual.

Which systems show it

• MRCOOL DIY 5th Generation single-zone 9k, 12k, 18k, 24k, and 36k D25 indoor/outdoor models listed in manual section 1.1.

Related troubleshooting

Use the symptom guide alongside the exact display code if the unit is flashing, cycling, or showing comfort symptoms.

Manual trigger

High temperature protection of the evaporator.

Related codes

Source

Next step