ACiQ PC04 error code

What it means

PC04 means the outdoor inverter drive could not operate the compressor normally. This can involve the compressor, IPM, outdoor board, or drive wiring.

Urgency

Likely causes

1. Brief power event, brownout, or unstable supply voltage
2. Loose power connection, reactor, or outdoor electrical component problem
3. Inverter/IPM protection or current-detection fault
4. Compressor winding, drive, or outdoor board fault after power checks pass

Homeowner fix

Turn the system off with the remote, then power cycle once at the breaker or disconnect if you can do that safely. Expected result: a temporary control fault clears; if the code returns, stop resetting and schedule service.

When to call a pro

Call a licensed HVAC technician if PC04 returns after one reset or the outdoor unit will not start. Tell them the code is inverter compressor drive error.

Repair vs replace

This is normally a repair diagnosis, not an automatic replacement signal. If a technician confirms a major board, compressor, fan motor, or refrigerant-circuit repair on older out-of-warranty equipment, compare the quote with replacement.

• ACiQ Multi-Zone Extreme Series 2-Zone 18,000 BTU R-454B 208/230V (ACIQ-18Z-HH-M3C)

  Multi-Zone Extreme Series

• ACiQ Multi-Zone Extreme Series 3-Zone 27,000 BTU R-454B 208/230V (ACIQ-27Z-HH-M4C)

  Multi-Zone Extreme Series

• ACiQ Multi-Zone Extreme Series 4-Zone 36,000 BTU R-454B 208/230V (ACIQ-36Z-HH-M5C)

  Multi-Zone Extreme Series

• ACiQ Multi-Zone Extreme Series 5-Zone 48,000 BTU R-454B 208/230V (ACIQ-48Z-HH-M6C)

  Multi-Zone Extreme Series

For your technician

Technician note: service manual section 7.4.1.8 says compressor drive troubleshooting follows IPM module protection; diagnose compressor, IPM, wiring, and outdoor PCB. Page context: ACiQ maps this display to the Multi-Zone Extreme Series line; source: ACiQ Multi-Zone Service Manual and shared Midea D5CMRA Table 20 display reference; display convention: match the letter P, letter C, and four marker exactly before comparing neighboring codes.

Which systems show it

• ACiQ Multi-Zone Extreme Series R-454B systems using the shared Midea/ACiQ multi-zone platform.
• ACiQ Multi-Zone Standard Series R-454B systems where the ACiQ service manual lists the same EC/EH/EL/PC diagnostics.
• ACiQ wall-mounted, cassette, duct, console, and AHU indoor units listed in service manual section 7.2.

Sold under more than one brand

Shared with Midea. ACiQ and Midea document this code from the same manufacturer source, so PC04 means the same thing on either badge and the steps above apply.

Related troubleshooting

Use the symptom guide alongside the exact display code if the unit is flashing, cycling, or showing comfort symptoms.

Reset note

Turn the system off with the remote, then power cycle once at the breaker or disconnect if you can do that safely. Expected result: a temporary control fault clears; if the code returns, stop resetting and schedule service.

Manual trigger

PC04 means the outdoor inverter drive could not operate the compressor normally. This can involve the compressor, IPM, outdoor board, or drive wiring.

Related codes

Source

Next step