Carrier / Comfort 22
Carrier EH3B error code
EH3B means the external fan module is seeing DC bus voltage above its expected range. This is an electrical protection fault.
- Urgency
- advisory
- Verified
- Jul 31, 2026
- Fix path
- Technician
What it means
EH3B means the external fan module is seeing DC bus voltage above its expected range. This is an electrical protection fault.
Urgency
advisory
Try only the safe reset/check in the owner's manual. If the code returns, stop using the system until it is diagnosed.
Likely causes
- Carrier Table 4 identifies EH3b as external fan DC bus voltage too high fault.
- Carrier troubleshooting lists voltage too high or too low as a performance/fault cause.
- An electrical/control condition that does not clear after one safe reset.
Homeowner fix
Turn the system off with the remote, wait about 10 minutes, then power cycle once at the breaker or disconnect if you can do that safely. If the code returns, stop resetting and schedule service. Do not open the indoor or outdoor cabinet.
When to call a pro
Call a licensed HVAC technician or electrician if EH3B returns. Tell them Carrier identifies EH3b as external fan DC bus voltage too high fault.
This code points to electrical or inverter work - get repair quotes from contractors in your area.
Get repair quotesRepair vs replace
This is normally a repair diagnosis, not an automatic replacement signal. If a technician confirms a major board, compressor, fan-motor, or sealed-system repair on older out-of-warranty equipment, compare the quote with replacement.
See Carrier mini-splitsYour Carrier model
Comfort 22 model pages in the Carrier catalog help compare this repair path with current replacement options.
- Carrier Comfort 22 9,000 BTU R-454B 115V (45MHHAQ09XC1 / 37MHRAQ09AA1)
Comfort 22
- Carrier Comfort 22 9,000 BTU R-454B 208/230V (45MHHAQ09XC3 / 37MHRAQ09AA3)
Comfort 22
- Carrier Comfort 22 12,000 BTU R-454B 115V (45MHHAQ12XC1 / 37MHRAQ12AA1)
Comfort 22
- Carrier Comfort 22 12,000 BTU R-454B 208/230V (45MHHAQ12XC3 / 37MHRAQ12AA3)
Comfort 22
For your technician
Technician note: verify supply voltage under load, fan module DC bus, wiring, connectors, grounding, and control board output. Page context: Carrier maps this display to the Comfort 22 line; source: Carrier 45MHHAQ High Wall Heat Pump Owner's Manual, Table 4 Error Codes; display convention: match the letter E, letter H, three, and letter B marker exactly before comparing neighboring codes.
Which systems show it
Comfort 22
Related troubleshooting
Use the symptom guide alongside the exact display code if the unit is flashing, cycling, or showing comfort symptoms.
Related codes
Source
- Document
- Carrier 45MHHAQ High Wall Heat Pump Owner's Manual, Table 4 Error Codes