Midea ECC1 error code

What it means

ECC1 means the leak alarm came from a different indoor head on the same multi-zone system. Treat the whole system as unsafe until a technician verifies the leak sensor and refrigerant circuit.

Urgency

Likely causes

1. Actual refrigerant leak at a flare joint, coil, line set, or service connection
2. Low refrigerant charge or charge loss after installation or service
3. Refrigerant sensor, T1/T2, or related control input reading abnormally
4. Indoor or outdoor board fault only after the leak and sensor checks pass

Homeowner fix

Turn the system off, ventilate the space, avoid flames, sparks, and smoking, and do not reset the unit back into normal operation. Expected result: the system stays off until a licensed technician verifies the leak sensor and refrigerant circuit.

When to call a pro

Call a licensed HVAC technician immediately. Tell them the display is ECC1 and that another indoor unit's refrigerant sensor reported leakage.

Repair vs replace

A leak-sensor replacement or minor leak repair may be reasonable, especially under warranty. If the repair involves a coil, buried line set, or repeated refrigerant loss, compare the quote with replacement.

• Midea Advantage Series Multi-Zone 3-Zone 18,000 BTU R-454B 208/230V (D5CMRAH18CAK)

  Advantage Series Multi-Zone

• Midea Advantage Series Multi-Zone 4-Zone 24,000 BTU R-454B 208/230V (D5CMRAH24DAK)

  Advantage Series Multi-Zone

• Midea Advantage Series Multi-Zone 5-Zone 30,000 BTU R-454B 208/230V (D5CMRAH30EAK)

  Advantage Series Multi-Zone

• Midea Advantage Series Multi-Zone 5-Zone 36,000 BTU R-454B 208/230V (D5CMRAH36EAK)

  Advantage Series Multi-Zone

For your technician

Technician note: follow R-454B/A2L leak-safety procedures, identify the reporting indoor unit, verify sensor operation, locate and repair any leak before restart. Page context: Midea maps this display to the Advantage Series Multi-Zone line; source: Midea D5CMRA Installation Instructions Table 20 and shared ACiQ/Midea Multi-Zone Service Manual; display convention: match the letter E, letter C, letter C, and one marker exactly before comparing neighboring codes.

Which systems show it

• Midea Advantage Series Multi-Zone D5CMRA R-454B outdoor condensers and matched indoor units covered by Table 20.
• Midea Advantage Series Multi-Zone High-Heat D5CMHA systems where the D5C installation/error-code convention is shared.
• Midea current R-454B single-zone high-wall families when the indoor display uses the same EC/EH/EL/PC homeowner code convention.

Sold under more than one brand

Also sold as ACiQ. Midea and ACiQ document this code from the same manufacturer source, so ECC1 means the same thing on either badge and the steps above apply.

Related troubleshooting

Use the symptom guide alongside the exact display code if the unit is flashing, cycling, or showing comfort symptoms.

Reset note

Turn the system off, ventilate the space, avoid flames, sparks, and smoking, and do not reset the unit back into normal operation. Expected result: the system stays off until a licensed technician verifies the leak sensor and refrigerant circuit.

Manual trigger

ECC1 means the leak alarm came from a different indoor head on the same multi-zone system. Treat the whole system as unsafe until a technician verifies the leak sensor and refrigerant circuit.

Related codes

Source

Next step