Mitsubishi Electric UP error code

What it means

UP means the outdoor unit is protecting the compressor or inverter drive. Homeowner checks are limited because the expensive parts are inside the outdoor cabinet. If one reset does not hold, the compressor-drive circuit needs professional diagnosis. Manual trigger: Overcurrent protection cut-out operates 3 consecutive times within 1 minute after compressor start.

Urgency

Likely causes

1. Brief power event, brownout, or unstable supply voltage
2. Loose power connection, reactor, or outdoor electrical component problem
3. Inverter/IPM protection or current-detection fault
4. Compressor winding, drive, or outdoor board fault after power checks pass

Homeowner fix

Turn the system off for 2 minutes, restore power once, and listen for normal startup. If the code returns, do not keep trying to force the compressor to start.

When to call a pro

Call a licensed HVAC technician if the code returns after one reset, the outdoor unit hums or clicks, or the breaker trips. Tell them the code is tied to compressor, IPM, inverter, or startup protection.

Repair vs replace

Compressor or inverter repairs can become expensive. If a technician confirms compressor, IPM, or sealed-system damage on an older unit, compare the repair quote with replacement before approving it.

• Mitsubishi Electric M-Series GX 9,000 BTU R-454B 208/230V (MSZ-GX09NL / MUZ-GX09NL)

  M-Series GX

• Mitsubishi Electric M-Series GX Hyper-Heat 9,000 BTU R-454B 208/230V (MSZ-GX09NL / MUZ-GX09NLHZ)

  M-Series GX

• Mitsubishi Electric M-Series GX 12,000 BTU R-454B 208/230V (MSZ-GX12NL / MUZ-GX12NL)

  M-Series GX

• Mitsubishi Electric M-Series GX Hyper-Heat 12,000 BTU R-454B 208/230V (MSZ-GX12NL / MUZ-GX12NLHZ)

  M-Series GX

Parts for this line

The parts catalog for Mitsubishi Electric M-Series GX lists 6 sourced replacement parts for this product line.

For your technician

Technician note: check compressor wiring, winding, IPM/inverter output, stop-valve position, and refrigerant-circuit load in the manual order. Page context: Mitsubishi Electric maps this display to the M-Series GX line; source: Mitsubishi Electric MSZ-GX/MUZ-GX R454B service manuals; display convention: match the letter U and letter P marker exactly before comparing neighboring codes.

Which systems show it

• Mitsubishi Electric M-Series R454B wall-mount outdoor units covered by MUZ-GX OBH951C and cross-checked against MUZ-FX OBH946C and MUZ-WX OBH955A.

Related troubleshooting

Use the symptom guide alongside the exact display code if the unit is flashing, cycling, or showing comfort symptoms.

Reset note

After the documented cause is corrected, operate the unit and confirm the failure-mode recall/error-code display returns to 00.

Manual trigger

Overcurrent protection cut-out operates 3 consecutive times within 1 minute after compressor start.

Related codes

Source

Next step