GREE H7 error code

What it means

H7 means the inverter drive lost normal synchronization with the compressor. The unit may try to start and then stop because the compressor is not following the drive signal as expected.

Urgency

Likely causes

1. Temporary protection event that may clear after one reset
2. Airflow, power, or operating condition outside normal range
3. Sensor, wiring, or control feedback problem
4. Technician-only component fault identified by the service manual

Homeowner fix

Turn the unit off and reset power once. Expected result: a one-time startup fault clears; if H7 returns, leave the system off and call for service.

When to call a pro

Call a licensed HVAC technician if H7 returns or the outdoor unit repeatedly tries and fails to start. Tell them the code is compressor desynchronizing.

Repair vs replace

Compressor synchronization faults can lead to major inverter or compressor quotes. Compare major repairs with replacement on older or out-of-warranty systems.

• GREE Livo R32 9,000 BTU (230V)

  Livo R32

• GREE Livo R32 9,000 BTU R-32 115V (LIV09HP115V1R32AH / LIV09HP115V1R32AO)

  Livo R32

• GREE Livo R32 12,000 BTU (230V)

  Livo R32

• GREE Livo R32 12,000 BTU R-32 115V (LIV12HP115V1R32AH / LIV12HP115V1R32AO)

  Livo R32

Parts for this line

The parts catalog for GREE Livo R32 lists 8 sourced replacement parts for this product line.

For your technician

Technician note: check compressor windings/leads, phase current, inverter output, IPM condition, and startup load per the service procedure. Page context: GREE maps this display to the Livo R32 line; source: GREE R32 residential mini-split service manuals; display convention: match the letter H and seven marker exactly before comparing neighboring codes.

Which systems show it

• GREE LIVO R32 wall-mounted single-zone systems.
• GREE VIREO R32, ENVO R32, and Sapphire R32 wall-mounted single-zone systems using the common GREE R32 high-wall diagnostic table.
• GREE Free Match/Multi R32 and Free Match ECO/Multi ECO R32 systems when the connected indoor unit uses this common GREE indoor display table; GREE notes that multi-zone codes can differ by indoor unit type.

Related troubleshooting

Use the symptom guide alongside the exact display code if the unit is flashing, cycling, or showing comfort symptoms.

Reset note

Turn the unit off and reset power once. Expected result: a one-time startup fault clears; if H7 returns, leave the system off and call for service.

Manual trigger

H7 means the compressor has gone out of synchronization.

Related codes

Source

Next step