GREE PU error code

What it means

PU means the inverter or power-detection section saw an abnormal electrical condition and protected the unit. Homeowners should not open the outdoor cabinet or test live components; write down the code and arrange service if one reset does not clear it. Manual trigger: PU means the outdoor unit detected capacitor charging malfunction.

Urgency

Likely causes

1. Temporary protection event that may clear after one reset
2. Airflow, power, or operating condition outside normal range
3. Sensor, wiring, or control feedback problem
4. Technician-only component fault identified by the service manual

Homeowner fix

Turn the system off, wait several minutes, and reset power once if you can do so safely. Expected result: a brief utility disturbance clears; if the code returns, leave the system off and call for service.

When to call a pro

Call a licensed HVAC technician if PU returns, the breaker trips, or the outdoor unit will not start. Tell them the code points to capacitor charging malfunction.

Repair vs replace

Power-stage faults can be simple wiring or setup issues, but inverter, module, or compressor findings can be costly. Compare a major repair quote with replacement on older equipment.

• GREE Livo R32 9,000 BTU (230V)

  Livo R32

• GREE Livo R32 9,000 BTU R-32 115V (LIV09HP115V1R32AH / LIV09HP115V1R32AO)

  Livo R32

• GREE Livo R32 12,000 BTU (230V)

  Livo R32

• GREE Livo R32 12,000 BTU R-32 115V (LIV12HP115V1R32AH / LIV12HP115V1R32AO)

  Livo R32

Parts for this line

The parts catalog for GREE Livo R32 lists 8 sourced replacement parts for this product line.

For your technician

Technician note: follow discharge safety procedures, check precharge/charging circuit, DC bus behavior, drive-board components, and supply voltage. Page context: GREE maps this display to the Livo R32 line; source: GREE R32 residential mini-split service manuals; display convention: match the letter P and letter U marker exactly before comparing neighboring codes.

Which systems show it

• GREE LIVO R32 wall-mounted single-zone systems.
• GREE VIREO R32, ENVO R32, and Sapphire R32 wall-mounted single-zone systems using the common GREE R32 high-wall diagnostic table.
• GREE Free Match/Multi R32 and Free Match ECO/Multi ECO R32 systems when the connected indoor unit uses this common GREE indoor display table; GREE notes that multi-zone codes can differ by indoor unit type.

Related troubleshooting

Use the symptom guide alongside the exact display code if the unit is flashing, cycling, or showing comfort symptoms.

Reset note

Turn the system off, wait several minutes, and reset power once if you can do so safely. Expected result: a brief utility disturbance clears; if the code returns, leave the system off and call for service.

Manual trigger

PU means the outdoor unit detected capacitor charging malfunction.

Related codes

Source

Next step